Floor Sanding in Newcastle
Restoring Colour and Shine to Worn Boards
Timber that's gone grey and dull hasn't worn out. What you're looking at is a failed coating and a thin damaged layer sitting on top of otherwise sound boards, and both of those come off. At Freedom Flooring, floor sanding in Newcastle means working through four grit stages with belt and rotary machines to level the surface, cut away the old finish and leave clean timber ready for recoating. Deeper problems sometimes show up once that top layer is gone, and a floor in that condition is better served by full timber floor restoration than a straight sand. We'll tell you which one you're looking at during the free measure. Call 0404 606 142 to book it.
How We Approach a Sand and Polish
Every floor comes up differently, but the sequence we follow doesn't change.
We start by checking board condition, nail heads and gaps before any machine touches the floor. Punching nails and securing loose boards first is what prevents belt damage and ridging later on.
The cut runs through four grit stages, coarse through to fine. Skipping a grit leaves scratch marks that the coating magnifies rather than hides, so each pass has to fully remove the one before it.
Edges, corners and doorways are done separately with rotary and hand tools. This is the part that shows in a finished floor, because a machine-sanded field next to an untouched edge is obvious under light.
Dust extraction runs throughout, and we vacuum and tack the floor before coating. Contaminated coatings are the most common cause of a finish that looks cloudy or fails early.
FAQs
- It depends on the wear layer above the tongue, which on solid boards is usually enough for several full sands across the floor's life. Engineered boards carry a thinner veneer and will take fewer, sometimes only one or two.
- Sanding removes the old finish and the damaged top layer of timber to level the surface. Polishing refers to the coating applied afterwards, which is what produces the sheen and protects the bare timber underneath.
- Modern machines run with vacuum extraction that captures the bulk of it at the source, so it's far less than older drum sanding produced. Some fine dust still settles, which is why floors are vacuumed and tacked before any coating goes on.